OFFROAD.GUIDEBuilt your way. No haggling.
Four-wheel-drive vehicles on the wide dry sand of the Carova 4x4 beach.

Drivetrains · 4H and 4L

4 High vs. 4 Low

4 High is for going normal speeds on a slippery surface. 4 Low is for going slowly with a lot of pull. Written by Beach 4x4, 6+ years renting four-wheel-drive vehicles on the Outer Banks.

The short answer

4 High for slippery. 4 Low for slow and hard.

In both settings the engine drives all four wheels. The difference is gearing. 4 High (4H) uses the same gearing as two-wheel drive, so you drive at normal speeds with twice the wheels pulling. 4 Low (4L) runs the power through an extra set of gears in the transfer case that multiplies pulling force and cuts your speed. Jeep’s standard Wrangler system multiplies it 2.72 times; the Rubicon’s multiplies it 4 times.

You will use 4 High nine times out of ten: snow, ice, rain-slick dirt, the beach. 4 Low is for the tenth time: stuck, steep, or pulling something heavy across soft ground.

Side by side

Which setting for which day

For part-time four-wheel drive, the kind in most pickups, the Wrangler and the Bronco.
SituationUseWhy
Dry or merely wet pavement2HPart-time 4WD binds in turns when the tires have full grip
Snow-covered or icy road4HNormal speeds, four wheels pulling
Patchy road, clear then slick4 Auto if you have it; otherwise 4H on the slick stretches4 Auto adds the front axle only when the rear slips
Beach sand, aired down4HSteady momentum matters more than gearing
Gravel or a muddy dirt road4HSame reason as snow
Stuck in sand, snow or mud4LSlow, controlled pull without spinning the tires
Deep unplowed snow at walking speed4LMore pull at low speed
Steep hill, up or down, off pavement4LPull on the way up; engine braking on the way down
Boat ramp or a trailer in soft ground4LPulling force without cooking the transmission

How to shift

Getting into 4 High and 4 Low without grinding

  • Into 4 High: on the move. Most modern trucks shift from 2H to 4H while driving. Jeep says up to 55 mph in a Wrangler. Ease off the gas for a second while it engages, and do it before the wheels are spinning, not after.
  • Into 4 Low: nearly stopped, in neutral. Ford’s F-150 manual says 3 mph or less with the transmission in neutral. Jeep says to roll at 2 to 3 mph in neutral and move the lever firmly without pausing. Many trucks want a full stop. Then go back to drive.
  • Out of 4 Low: the same way. Slow to a crawl or stop, neutral, shift back to 4H, then drive.
  • If it will not go in. Roll forward a few feet and try again. The gears sometimes need to line up.
  • Back to 2H on clear pavement. Do not leave part-time four-wheel drive engaged on a dry road.

What it will not fix

What 4 Low cannot do

4 Low multiplies pull. It does not add grip and it does not lift the truck. If the frame is sitting on the sand and the tires are hanging in holes they dug, more torque just digs deeper.

So before you reach for 4 Low, look underneath. If the axles or the frame are buried, stop. Dig the sand out from in front of all four tires and from under the truck, let more air out, and then ease out in 4 Low the way you came in. Traction boards under the tires help. If it is sitting on its belly, a tow is cheaper than a transmission.

If 4 Low will not engage at all, you are usually rolling too fast or still in drive. Stop, shift to neutral, select 4 Low, wait for the light, then shift back to drive. If it still balks, roll forward a few feet and try again.

How fast

Speed in 4 High and 4 Low

4 High has no special speed limit of its own. Drive at a speed that suits the surface, which in snow or on sand is well below the posted limit anyway.

4 Low is a crawling gear. In low range the engine turns about three times as fast for the same road speed, four times in a Wrangler Rubicon, so you run out of gearing quickly. Jeep’s owner’s manuals have told drivers not to exceed 25 mph in 4L. If you are going faster than a jog for more than a minute, you belong in 4 High.

And remember what four-wheel drive does not do. It helps you go. It does not help you stop or steer on ice. Braking grip comes from the tires.

On the sand

4 High or 4 Low on the beach

  • Air down first. 18–20 psi for SUVs and half-ton pickups. Three-quarter-ton and heavier pickups keep 18–20 in the rear but run more up front: 22–25 psi with gas, 25–28 with a diesel. Four-wheel drive does far less without it.
  • 4 High for driving the beach. That is where you will spend nearly all your time. In a truck with 4 Auto, lock it into 4 High so the front axle pulls all the time.
  • 4 Low when it gets soft and slow. Backing out of a hole you dug, pulling a boat trailer through deep sand, or creeping up a steep beach ramp.
  • Stuck? Stop spinning. Spinning digs you in. Let more air out, clear the sand from in front of the tires, select 4 Low and ease out the way you came in.

More: 4WD vs. AWD, low range and airing down in the 4x4 terms guide, and your first beach drive.

Questions

Quick answers

What is the difference between 4 High and 4 Low?

Both drive all four wheels. 4 High uses normal gearing and is for slippery surfaces at normal speeds. 4 Low sends power through an extra set of gears that multiplies pulling force about two and a half to four times, for crawling at low speed.

Should I use 4 High or 4 Low in snow?

4 High for snow-covered and icy roads. 4 Low only when you are stuck, breaking through deep unplowed snow, or creeping down a steep icy grade.

Should I use 4 High or 4 Low on the beach?

4 High, after airing down to 18–20 psi. Use 4 Low to back out of a soft spot or to pull a trailer through deep sand.

How fast can you drive in 4 High?

At normal road speeds for the conditions. The limit is on shifting, not driving: Jeep, for example, says to shift a Wrangler from 2H to 4H at up to 55 mph. If conditions are bad enough to need 4 High, they are bad enough to slow down.

How fast can you drive in 4 Low?

Slowly. In low range the engine turns roughly three times as fast for the same road speed, four times in a Wrangler Rubicon. Jeep’s manuals have told owners not to exceed 25 mph in 4L.

Can I shift into 4 Low while moving?

Barely. Ford’s F-150 manual says 3 mph or less with the transmission in neutral. Jeep says to roll at 2 to 3 mph in neutral. Many trucks want a full stop.

Is it bad to drive in 4 High on dry pavement?

With part-time four-wheel drive, yes. The front and rear axles are locked together, so the driveline binds in turns on a surface with full grip. Go back to 2H when the road is clear, or use 4 Auto if your truck has it.

OffRoad.guide · Open all year

Half a day on the sand. Then the price, in writing.

Request your date

$325 a vehicle for the full five and a half hours, any month of the year. Request a date on the main page to get first pick. We email you to confirm it, with the booking link and the online license and insurance check. Questions? Email hello@offroad.guide; answers come back the same day.

How it works

Keys at the Hilton Garden Inn in Kitty Hawk, half a day up North Carolina Highway 12 and the Carova 4x4 beach, your family along and no salesperson. Then the No-Haggle Price in writing. The whole experience, start to finish.

Shopping with someone?

Send them this page.